View PDF | Print View | Html Version
by: JasonLancaster
Total views: 1
Word Count: 635

Any mechanic or automotive enthusiast can tell you that an engine is essentially a large air pump. The more an engine can suck in air to mix with fuel, the more it can create power through combustion. Thus, the more efficiently an engine removes exhaust gases from the cylinders, the better it can manage that power. The key to a strong, healthy engine is adequate air from one end to another.

Many different things can affect air flow in a motor, but the primary control over the volumes of air entering a cylinder, and exhaust leaving it, comes from the valves in the cylinder head. The intake valves open immediately before combustion to allow air to flow in and combine with the fuel. After this mixture has been ignited, the exhaust valves open and suck out the resulting gases. Valve timing is controlled by the camshaft, which is a rotating shaft with lobes pushing up on the valves to open them, then drop them closed again.

An engine's drivability and power can really be affected by length of time and the point in the combustion cycle at which the valves are open. A really fast car, such as a race car, will need an engine that produces lots of power at high RPMs. To get this, the camshaft can be adjusted to perform well at higher RPMs, but the trade-off will be poor performance at low RPMs. Following the same principle, adjusting the camshaft to perform best at low RPMs will give you lots of low-end torque, which is great for jobs like towing, but your high RPM performance will suffer.

Unfortunately, street vehicles are a compromise between reliability, fuel efficiency and power. While race vehicles have engines with camshaft designs that generate large amounts of power while being used only at specific, high revolutions, your daily driver sees a wide range of RPMs that make a broader power band necessary. While it is ok for a race car to have a lumpy idle that barely runs below 1000 rpm, it would do you no good if your street car stalled out at every stoplight. Regular vehicles usually have to make do with a camshaft that provides a good amount of power in the most often used range of engine RPMs, but runs out of steam at high speeds.

These compromise camshafts aren't terribly efficient. Because they try to do so many things - from accelerating your car from a dead stop to providing performance at highway speeds, and everything in between - they don't do any one of them very well. This means that your engine burns too much fuel most of the time, while also underperforming.

Automakers have developed something called "variable valve timing" (VVT) to address this problem. Toyota's newest VVT-i engine, the Toyota Tundra's i-Force 5.7L V8, can vary the timing of the valves to match engine speed. It uses engine oil pressure to make slight adjustments to the camshaft, so that more aggressive lobe designs are used when working at higher RPMs. This makes the i-Force capable of running a camshaft configuration which provides fuel efficiency for everyday driving, but that can still turn out lots of power when you press the pedal to the floor.

The dual VVT-i in the Toyota Tundra goes even further - at high RPMs, it allows the exhaust and intake valves to open at the same time, which scavenges airflow as much as possible. The result? A V8 engine that can produce 381 horsepower at 5600 rpm, but also generate 401 lb-ft of torque at as little as 3600 rpm. And what's more, the 2 wheel drive Tundra can still get a respectable 20 miles per gallon on the highway. Possibly the best part about Toyota's variable valve timing system is getting killer horsepower without getting killed at the pump.

About the Author

Author Jason Lancaster operates TundraHeadquarters.com, a web site with information, news, and reviews of Toyota Tundra accessories and Tundra parts.

Add Comment